Novelty Test Report VIII - Leather

Riverbank Acoustical Laboratories Novelty Testing report on cow hide leather sound transmission test

In old movies, you'd see bank presidents, politicians, and mob bosses all disappear behind the same heavy leather door. They'd swing the door shut behind them, and the outside world goes silent. We wanted to see if that "technology" holds up. 

For the latest installment of Riverbank's Novelty Testing Series, we tested a 1.4 mm sheet of premium top-grain cow hide leather to determine its sound transmission loss and single-number sound insulation ratings using ASTM E90 and ASTM E413 procedures. 

The leather posted a Sound Transmission Class (STC) of 12 and an Outdoor-Indoor Transmission Class (OITC) of 8 — numbers that put the "leather door = privacy" myth to rest. If you want a leather door that actually keeps conversations inside the room, you need some major engineering underneath that exterior. Check out our latest novelty test report to see the full transmission loss data across the frequency range we tested. Download the report at the link below to add to your library and share with your friends and colleagues.

Download The Report

After testing, all leather pieces were donated to the Chicago School of Shoemaking and Leather Arts.


Riverbank Acoustical Laboratories Novelty Testing logo: "Fun Tests · Serious Results" banner

About Our Novelty Testing Program

RAL will be performing a series of self-sponsored tests and publishing the results for wide dissemination across the acoustics community. Send us your suggestions for our next test! We are looking to test commodity materials or systems where data is needed but does not exist due to a lack of a traditional sponsor.

The Rules:

  • Test samples should be made from commodity materials, no specific acoustical product systems
  • The tests would not have a conventional sponsor interest, so they are not likely to happen in the acoustical testing marketplace
  • The results have some utility or interest to the broad acoustics community

Submit Your Ideas by Emailing Us
info@riverbankacoustics.com

Recent Posts


Novelty Test Report IX - Steel

We tested a 4' x 8' sheet of 1/4-inch steel to measure its sound transmission loss and single-number sound insulation ratings (STC/OITC) using ASTM E90 and E413 procedures. It turns out the vault-door silence from the movies takes more than a sheet of steel. Check out our latest novelty test report to see the full results.

Read more …


Novelty Test Report VIII - Leather

We tested 1.4 mm of premium top-grain cowhide leather to determine its sound transmission loss and insulation ratings using ASTM E90 and ASTM E413 procedures. The results may surprise you. Check out our latest novelty test report to see how leather performed in Riverbank’s transmission loss suite.

Read more …


Novelty Test Report VII - Sand

We tested approximately 5-1/2 inches of fine mason sand to determine its sound absorption coefficients across a wide range of frequencies using ASTM C423 procedures. The results may surprise you. Check out our latest novelty test report to see how this common material performed in Riverbank’s reverberation chamber.

Read more …